Tools
Ignition system tester
Ignititon system tester, connect this to your sparkplug cap and see how far the spark will jump. A g..
$10.00
JB Fabrication Lambretta crank remover tool
JB Fabrication Lambretta crank remover tool, used to push your series 1-3 crank out of the bearing i..
$20.00
JB Fabrication Lambretta engine repair stand
JB Fabrication Lambretta engine repair stand for LI series 1-3, TV2, S, SX, GP/DL, Serveta engines.&..
$120.00
Layshaft holding tool
Another essential workshop tool. Used for holding any Series 1-3 and DL/GP layshaft so you can use y..
$35.00
Layshaft pulling sleeve
It is important, when checking the tolerances in the gearbox, that the layshaft is pulled all the wa..
$25.00
MB Chain alignment tool
Chain alignment tool for checking that the sprockets are in line and you chain will run straight. To..
$51.00
MB Conrod holding tool
This tool will work on any single cylinder engine. It is designed to rest on the base gasket face an..
$35.00
MB Crankshaft drive side bearing drift tool, Lambretta
This MBD tool is designed to make it easy and safe to refit the crankshaft drive side bearing...
$30.00
MB Crankshaft flywheel side bearing inner sleeve drift Lambretta
Crankshaft flywheel side bearing inner sleeve drift. This tool is designed to safely and easily fit ..
$30.00
MB Crankshaft pulling sleeve
There is no point spending money on a crank that has been checked for alignment then going and hitti..
$35.00
MB end plate and magneto housing pullers: T-handle tools
MB end plate and magneto housing pullers: T-handle tools..
$25.00
MB End plate bearing drift tool, Lambretta
This MBD tool is designed to make it easy and safe to refit the endplate bearing...
$15.00
MB engine silent block removal and installation tool
Complete engine mount silent block removal and installation tool. Designed to aid in the remova..
$70.00
MB flywheel holding tool: standard flywheels
The flywheel holder is one of the must-have tools for the Lambretta. Unlike as on other scoot..
$42.00
MB Fork link bushing drift tool, Lambretta
This tool, made by us (MBD), is designed to safely and easily remove the two fork link bushes. It is..
$17.00
MB frame steering bearing race fitting tool
This tool draws in the top and bottom steering races that press fits into the frame on all Series 1,..
$35.00
MB Front hub bearing and seal drift tool, Lambretta
This MBD designed tool is made to safely and easily refit front hub bearings and seal. It helps yo..
$16.00
MB kick start modification tool
Crankcase side kickstart modification tool. This will safely machine the side casing on Series 1,..
$58.00