Control Cables
Gear selector linkage set: series 1-3, GP/DL, Serveta
Gear selector linkage set: series 1-3, GP/DL, Serveta..
$73.00
Gear selector tie bar rubber
This rubber cover goes over the end of the gear selector tie bar and protects the end of the gear se..
$4.00
Gear swivel (Casa)
Gear cable swivel assembly. Always make sure the swivel spins freely on the pivot and grease them on..
$15.00
Gear swivel pivot base, standard
Gear swivel pivot base, standard on all Series 1-3 Lambretta...
$12.00
Gear/Clutch cable adjuster
These adjusters will fit the standard adjuster block or the MBD improved cable adjuster block. Alway..
$3.99
Gear/Clutch cable adjuster set, extended: stainless
New! Set of 3 x extended neck adjusters for control cables on top of engine (stainless) A while a..
$16.00
Gear/Clutch cable adjuster set, extended: zinc plated
New! Set of 3 x extended neck adjusters for control cables on top of engine (zinc plated) A while..
$13.00
Hydraulic banjo bolt washers: 10mm crush washer
Hydraulic banjo bolt washers: 10mm crush washer. SOLD EACH!..
$0.60
Hydraulic brake hose with 8mm and 10mm ends
Hydraulic brake hose with 8mm and 10mm ends for use with Casa Performance master cylinder and any ca..
$55.00
Rear brake cable adjuster
Adjuster screw rear brake cable -LAMBRETTA- LI, LIS, SX, TV, DL, GP - Zinc plated. Made in Italy...
$15.00
Rear brake cable guide
This bracket sits under the cable adjuster block and holds the rear brake cable away from the rear..
$6.00
Rear brake cable protection
This rubber sleeve fits over your rear brake cable inner where it is exposed between the t..
$3.00
Rear brake pedal bushing
Rear brake pedal bronze bushing for all Series 1-3, DL/GP, A-F, LC, D/LD and J-range Lambretta...
$8.00
Rear brake pedal cable clamp pinch bolt
This item secures the rear brake cable to the brake pedal on all Series 1-3 Lambrettas. Includes nut..
$5.00
Rear brake pedal cable clamp plate pin
Pin to secure the rear brake pedal cable clamp plates on all Series 1-3 and DL/GP models. Includes p..
$4.00
Rear brake pedal cable clamp plates
Pair of rear brake cable clamp plates for the rear brake pedal on all Series 1-3 Lambretta. Made in ..
$8.00
Rear brake pedal return spring: Series 1
Rear brake pedal spring for all Series 1 Lambretta...
$12.00
Rear brake pedal return spring: Series 2-3, DL/GP, Serveta
Rear brake pedal spring for all Series 2-3 and DL/GP Lambretta...
$12.00
Rubber frame ignition wire/throttle cable grommet: Series 1-3, DL/GP
This rubber piece fits against the frame to hold the ignition wire and throttle cable in plac..
$3.00