Frame & Suspension
16mm half nut, rear shock nut
Used on all Lambretta Series 1-3, and DL/GP and Serveta rear shocks.Sold each...
$1.25
16mm spring washer (wavy): Zinc
Used under the rear shock and engine pivot bolt nuts.Sold each!..
$1.25
BGM 10% uprated front fork springs: Lambretta series 1-3, DL/GP, Serveta
Fork springs for all Lambrettas of the Li family (Li, LiS, TV, GT, SX, DL, GP).The springs are 10 % ..
$30.00
BGM adjustable rear shock Lambretta: black
The V3 version of our rear Lambretta shock absorber. Compared to its predecessor, all the proven fea..
$300.00
BGM adjustable rear shock Lambretta: chrome
The V3 version of our rear Lambretta shock absorber. Compared to its predecessor, all the proven fea..
$320.00
BGM rear shock absorber spacer
This spacer is needed when fitting an Italian spec rear shock to a later Spanish Serveta frame or en..
$12.00
BGM rear shock replacement bushing
Replacment bushing for the v2 BGM adjustable rear shock absorber, Lambretta models...
$15.00
Bodywork hardware kit: Series 2
You can take the guesswork out of rebuilding your series 2 Lambretta by using our popular bodywork h..
$50.00
Center stand bracket set
These hooks are normally tack welded to the original splash plate but if yours snaps off and you los..
$20.00
Center stand bracket set, stainless
These hooks are normally tack welded to the original splash plate but if yours snaps off and you los..
$100.00
Center stand feet pin: standard
Used to secure the rubber centerstand feet to the centerstand. Sold each, you need two per scoote..
$1.00
Center stand reinforcement plates
It is commonly found that Lambrettas are wobbly on the stand and end up sitting lower and lower on t..
$8.00
Center stand splash plate bracket: Series 1-2 (early)
Center stand splash plate bracket for all Series 1 and Series 2 up to 1960. SOLD EACH, you need two ..
$6.00
Center stand splash plate: Series 1-2 (early)
Centerstand splash plate for all Series 1 and Series 2 up to 1960. This is the type with four mounti..
$35.00
Center stand splash plate: Series 2 (late)
Center stand splash plate for all Series 2 after 1960. Made in Italy...
$40.00
Center stand splash plate: Series 3
Center stand splash plate for all Series 3, DL/GP Lambretta. Powder coated and comes with the hooks ..
$40.00
Center stand spring: Series 1-3, DL/GP, Serveta
Standard steel center stand return spring. Made in Italy...
$12.00
Center stand spring: Series 1-3, DL/GP, Serveta, stainless
Remade stand spring using a genuine Italian spring as a pattern so it will fit exactly as per o..
$20.00