Search
Products meeting the search criteria
Crankcase and gearbox dowel pin
These dowel pins fit in your engine case and are used to locate the crankcase side. They are also ..
$1.00
Crankcase side cover engine oil magnetic drain plug
Modern magnetic drain plug with rubber gasket for all Series 1-3, DL/GP engines. It is fitted with a..
$16.00
Crankcase side cover engine oil magnetic drain plug
Standard magnetic drain plug for all Series 1-3, DL/GP engines. It is fitted with a magnetic insert ..
$10.00
Crankcase side cover exhaust stud
This stud is used to hold the exhaust bracket to the main engine casing. You need two per engine cas..
$2.00
Crankcase side cover gasket
Crankcase side gasket to fit all Series 1, 2 or 3 crankcase sides (except TV Series 1)...
$6.00
Crankcase side cover stud
This stud is the normal length crankcase side stud of which you need 14 for most crankcases...
$2.00
Crankcase side cover stud, extra long for exhaust tailpipe
RLC has had all the main studs remade for Lambretta engines, to our exact requirements. This is..
$2.25
Cylinder head distance nut
This cylinder head distance nut is longer to connect to the cooling shroud. You need one per scooter..
$4.00
Dellorto replacement float: PHBL/PHBH
Replacement float for all Dellorto PHBH and PHBL carbs. ..
$35.00
End plate layshaft outer bearing race, Lambretta
This track is pressed into the gearbox endplate and the layshaft needle bearing rests in it. They ..
$17.00
Engine bump stop rubber buffer
This rubber buffer item sits in a hole on the top of your casing and supports your frame on your eng..
$5.00
Engine bump stop washer
This washer sits in the engine casing underneath the bump stop rubber...
$2.00
Engine pivot bolt, long
Fits any engine with the long type engine mounts in any Series 1-3 type frame...
$17.00
Engine pivot bolt, short
Fits any engine with the small type engine mounts in any Series 1-3 type frame, It comes complete wi..
$15.00
Engine silentblock (mount): 125-150
Quality engine mounts for smaller engine cases. Can be fitted to any Series 1, 2 or 3 125cc t..
$20.00
Gear box end plate stud
This stud is used to secure the gearbox end plate to the main engine casing. You need 6 per engine. ..
$3.00
Gear box end plate: Li/TV/SX
This is an endplate for a Li/TV/SX type Lambretta engine that uses the seperate kickstart ramp (not ..
$35.00
Gear selector arm shaft bushing
This bushing sits in your engine casing and the gear arm shaft goes through it. You only really ne..
$6.00