Tools
3.5mm allen key
This is the unusually sized 3.5mm allen key you need for most original gear and clutch cable trunn..
$3.75
3mm allen key
This 3mm allen key. They do not fit the oddly sized 3.5mm trunnions that were standard on Lambrett..
$3.75
Assembly and disassembly tool for gear selector -BGM PRO 'ball squeezer'- Lambretta LI, LIS, SX, TV (Series 2, Series 3), DL, GP
Assembly and disassembly tool for gear selector -BGM PRO 'ball squeezer'- Lambretta LI, LIS, SX, TV ..
$35.00
BGM Clutch spring locating tool
Tool for holding the clutch springs in place during assembly of your Lambretta Li series 1 and all s..
$30.00
BGM drive side bearing tool Lambretta LI/TV/S/SX/GP/Serveta
A high quality BGM workshop tool designed for removing and fitting Lambretta drive side bearings (63..
$70.00
BGM engine silentblock removal and installation tool
Complete engine mount silent block removal and installation tool. Designed to aid in the remova..
$70.00
BGM flywheel holding tool: BGM/Varitronic
BGM made holding tool for all BGM 12v electronic and Varitronic flywheels. ..
$17.00
BGM flywheel holding tool: BGM/Varitronic
BGM made holding tool for all BGM 12v electronic and Varitronic flywheels. One end secures to the ou..
$17.00
BGM piston stop / TDC tool
Piston stop as used for finding top dead center and adjustment of your timing. Fits all spark plug h..
$9.00
BGM PWK carb adjustment tool
Handy little tool specially made to remove/install all type of screws and jets on all PWK type car..
$8.00
BGM rear hub holding tool (Lambretta only!!)
An incredibly dynamic rear hub holding tool from BGM. Works with Lambretta large frame rear hubs. Mu..
$65.00
BGM rear hub holding tool (Vespa only!!)
An incredibly dynamic rear hub holding tool from BGM. Works with Vespa small frame and large frame m..
$65.00
BGM spark plug socket tool
Spark plug spanner 21mm -BGM PRO- with magnet- Only 65mm total height- SW 13 hexagon head and 1/4" d..
$25.00
BGM stud installation kit
This handy tool kit from BGM allows damage-free installations and removal of various case studs in M..
$25.00
BGM Timing disc
Tool for measuring the timings of the cylinder ports on any 2 stroke engine with a 10 or 12 mm threa..
$28.00
Blanking plate for leak down testing, Lambretta exhaust, oval
Blanking plate for leak down testing, Lambretta exhaust, oval. For standard and big bore type exhaus..
$10.00
Blanking plate for leak down testing, Lambretta exhaust, round
Blanking plate for leak down testing, Lambretta exhaust, round. For TS1, SS200, SS225, SST, SSR type..
$10.00
Blanking plate for leak down testing, Lambretta intake, 125-175cc
Blanking plate for leak down testing, Lambretta intake, 125-175ccConnect this to the cylinder where ..
$10.00
Blanking plate for leak down testing, Lambretta intake, 200cc
Blanking plate for leak down testing, Lambretta intake, 200ccConnect this to the cylinder where the ..
$10.00
Blanking plate for leak down testing, Vespa LF intake
Blanking plate for leak down testing, Vespa LF intake. Bolt this plate down to the engine case ..
$10.00